STUPIDSID
Solve any one question fromQ.1(a,b,c) and Q.2(a,b,c)
1(a)
Minimize the following logic function and realize using NAND gates:
F (A, B, C, D) Σm(1, 3, 5, 8, 9, 11, 15) + d(2, 13).
F (A, B, C, D) Σm(1, 3, 5, 8, 9, 11, 15) + d(2, 13).
4 M
1(b)
Write the rules for BCD addition and give example.
2 M
1(c)
Draw and explain 3 bit Asynchrous UP counter using MS-JK flip-flop, also draw timing diagram for the same.
6 M
2(a)
Design 16: 1 Multiplexer using 4:1 MUX. Explain the truth table of your design.
6 M
2(b)
Compare Moore and Mealy model.
2 M
2(c)
Convert the following flip-flop:
i) JK to T
ii) SR to D.
i) JK to T
ii) SR to D.
4 M
Solve any one question fromQ.3(a,b) and Q.4(a,b)
3(a)
What is an ASM chart? Draw an ASM chart and state table for 2 bit UP-down counter having mode control input M: When M =1: Up counting and When M=0: Down counting.
6 M
3(b)
Implement the following Boolean function using PAL: F1 = Σm (0, 2, 3, 4, 5, 6, 7, 8, 10, 11, 15)
F2=Σ(1, 2, 8, 12, 13)
F2=Σ(1, 2, 8, 12, 13)
6 M
4(a)
Write VHDL code for full adder using: i) Data Flow modeling
ii) Structural modeling.
ii) Structural modeling.
4 M
4(b)
Explain entity declaration for IC7432(OR gate).
2 M
4(c)
Implement 3 bit binary to gray code coverter using PLA.
6 M
Solve any one question fromQ5(a,b) and Q.6(a,b)
5(a)
Compare TTL and CMOS logic family and also draw CMOS - NOR gate.
7 M
5(b)
Draw three input standard TTL NAND gate circuit and explain its operation.
6 M
6(a)
State the following charteristics of digital TTL and CMOS Ics:
i) Figure of merit
ii) Noise immunity
iii) Speed of operation.
i) Figure of merit
ii) Noise immunity
iii) Speed of operation.
6 M
6(b)
What is logic family? Give the classfication of logic family in detail.
7 M
Solve any one question fromQ7(a,b) and Q.8(a,b)
7(a)
Draw explain architecture of microcontroller 8051.
7 M
7(b)
Explain any three addressing modes of 8051 with example.
6 M
8(a)
Discuss the function of PSW register in 8051 and also explain different flags available in PSW of 8051.
7 M
8(b)
Explain the following instructions with respective to 8051 and also give example of each:
i) MOV A, Rn
ii) SWAP A
iii) SET B.
i) MOV A, Rn
ii) SWAP A
iii) SET B.
6 M
More question papers from Digital Electronics and Logic Design