MU Electronics and Telecom Engineering (Semester 5)
RF Modelling and Antennas
December 2011
Total marks: --
Total time: --
INSTRUCTIONS
(1) Assume appropriate data and state your reasons
(2) Marks are given to the right of every question
(3) Draw neat diagrams wherever necessary


Write short notes on following :-
1 (a) Chip components
5 M
1 (b) Microstrip lines and strip lines
5 M
1 (c) Large signal FET model
5 M
1 (d) ABCD Parameters
5 M

2 (a) Explain what is Skin depth? Calculate the skin depth for copper and aluminium at 0.86 and 1.2 GHz? Also find the resistance of an 8 cm wire with diameter of 1.5 mm? \[ \sigma_{CU}=64.516 \times 10^6 (s/m), \ \sigma_{Al}=40\times 10^6 (s/m) \]
10 M
2 (b) Explain with the equivalent circuits the Radio frequency behavior of Resistor, Inductor and Capacitor?
10 M

3 (a) Explain the folllowing terms related to the filter Design? Insertion Loss, Ripple Factor, Bandwidth
6 M
3 (b) Explain why the ideal filter response cannot be realized?
4 M
3 (c) Design the Butterworth High pass filter having cutoff frequency of 250 MHz and -15dB response at 200 MHz?
10 M

4 (a) Plot the following Impedance points on the smith chart? Z0=50Ω
23+j 42Ω, 12-j 109Ω, 72+j 42.5Ω and 115-j 22Ω
Calculate their equivalent admittance using smith chart?
8 M
4 (b) Calculate the input impedance of the Transmission line using equations and the smith Chart, for Z0=50Ω, Z1=110+j 22Ω, εr=1.0, length of the line = 20 cm and operating frequency equal to 1.8 GHz?
12 M

5 (a) Explain the equivalent circuit of the transmission line?
5 M
5 (b) Derive the input impedance equation of Transmission line of length 'I'>
5 M
5 (c) Using the input impedance equation of Transmission line, derive the input impedance equation for shorted and open circuit transmission line and draw their voltage, current and impedance waveform?
10 M

6 (a) Define and derive AC parameter for BJT and FETs?
10 M
6 (b) Write short notes on,
(i) High Electron Mobility Transistor
(ii) Small signal BJT model?
10 M

7 (a) How the capacitor and inductors are realized using the sections of transmission line? Explain the same using the smith charts ?
6 M
7 (b) What are Kuroda Identities? How they are used in realization of RF filters?
10 M
7 (c) Explain what are Schottky Contacts?
4 M



More question papers from RF Modelling and Antennas
SPONSORED ADVERTISEMENTS