MU Microcontroller and Applications - December 2013 Exam Question Paper

MU Electronics Engineering (Semester 5)
Microcontroller and Applications
December 2013

Total marks: --
Total time: --

INSTRUCTIONS
(1) Assume appropriate data and state your reasons
(2) Marks are given to the right of every question
(3) Draw neat diagrams wherever necessary

1 (a) Design 8085 based system with following specification
Draw detail interface diagram.
(i) CPU operating at 3 Mhz
(ii) 16KB EPROM using 4KB device
(iii) 32KB RAM using 8KB device
Give its memory mapping & I/O mapping and use absolute decoding approach.

15 M

1 (b) Explain addressing modes with example of 8085 microprocessor

5 M

2 (a) Explain the Interrupt structure of 8085 microprocessor

10 M

2 (b) Explain with block diagram interfacing of 8255 PPI and 8085 microprocessor with control word for data transfer in handshake mode.

10 M

3 (a) Draw timing diagram for
(i) Opcode fetch
(ii)Memory read
(iii) I/O read

6 M

3 (b) Explain SIM & RIM instructions of 8085 microprocessor

4 M

3 (c) Explain interrupt structure of 8051 microcontroller

10 M

4 (a) Explain following instructions used in ARM with one example each
(i) LDM/STM (ii) BIC (iii) ADD/SUB (iv) MVN (v) BEQ

10 M

4 (b) Explain the CPSR register of ARM7 processor.

5 M

4 (c) Explain the flag register of 8085 microprocessor

5 M

5 (a) Write a program to generate square wave of 1KHz frequency using 8155 timer. (Timer operating at 3 MHz)

10 M

5 (b) Write a program to multiply two numbers for 8085 microprocessor

10 M

6 (a) Draw & Explain block diagram of 8259 peripheral IC

10 M

6 (b) Explain addressing modes with example of 8051 microcontroller

10 M

Write a short note on

7 (a) TCON & TMOD registers of 8051 Microcontroller

7 M

7 (b) Addressing modes of ARM processor

7 M

7 (c) Stepper motor interfacing with 8051 microcontroller

7 M

More question papers from Microcontroller and Applications

SPONSORED ADVERTISEMENTS