GTU Quality And Reliability Engineering - December 2014 Exam Question Paper

GTU Mechanical Engineering (Semester 7)
Quality And Reliability Engineering
December 2014

Total marks: --
Total time: --

INSTRUCTIONS
(1) Assume appropriate data and state your reasons
(2) Marks are given to the right of every question
(3) Draw neat diagrams wherever necessary

1 (a) Discuss views of different Quality Gurus.

7 M

1 (b) Explain 7 New Quality Improvement Tools.

7 M

2 (a) Explain Failure Mode and Effect analysis (FMEA).

7 M

Answer any two question from Q2 (b) or Q2 (c)

2 (b) Explain Total Quality Control.

7 M

2 (c) Discuss TQM Implementation and Limitations.

7 M

Answer any two question from Q3 (a), (b) or Q3 (c), (d)

3 (a) Explain Steps in experimental design.

7 M

3 (b) Explain KANBAN system.

7 M

3 (c) Briefly explain Taguchi approach.

7 M

3 (d) Explain Methods of Total Productive Maintenance.

7 M

Answer any two question from Q4 (a), (b) or Q4 (c), (d)

4 (a) (i) Short note:
Cost of Quality (COQ) system

4 M

4 (a) (ii) Bench marking.

3 M

4 (b) Discuss Advantages and Limitation of Six Sigma.

7 M

Write a short note on:

4 (c) (i) Discrete and continuous distribution.

4 M

4 (c) (ii) Bench marking.

3 M

4 (d) Explain Concurrent Engineering list out its merits and demerits.

7 M

Answer any two question from Q5 (a), (b) or Q5 (c), (d)

5 (a) Explain Reliability in terms of Hazard rate and failure density, Conditional Probability and multiplication rules

7 M

5 (b) (i) Short note:
Mean time to failure

3 M

5 (b) (ii) Mean time between failure

4 M

5 (c) (i) Short note:
Failure Data Analysis.

3 M

5 (c) (ii) Mean time to repair.

4 M

5 (d) (i) Explain QS 9000 list out its merits and demerits.

7 M

More question papers from Quality And Reliability Engineering

SPONSORED ADVERTISEMENTS