STUPIDSID
1 (a)
Define the term metrology. List and explain the objectives of metrology.
10 M
1 (b)
Explain with neat sketch: i) Imperial standard yard
ii) International prototype meter.
ii) International prototype meter.
10 M
2 (a)
Determine the tolerances on the hold and the shaft for a precision running bit designated by 50H7G6 Given:
i) 50mm lies between 30-50mm
ii) i(microns)=0.45(D)113+0.001D
iii) Fundamental deviation for 'g' shift= -2.5 D0.34
iv) IT7= 16i
v) IT6=10i.
i) 50mm lies between 30-50mm
ii) i(microns)=0.45(D)113+0.001D
iii) Fundamental deviation for 'g' shift= -2.5 D0.34
iv) IT7= 16i
v) IT6=10i.
12 M
2 (b)
Explain with neat sketches hole basis system and shaft basis system.
8 M
3 (a)
Explain with a neat sketch the working of sigma comparator.
10 M
3 (b)
Explain with a neat sketch the construction and working of a LVDT.
10 M
4 (a)
Explain with a neat sketch, Auto collimetor.
10 M
4 (b)
What are the various characteristics that you would measure in a crew thread? Explain 3 wire method of measuring effective diameter of screw thread.
10 M
5 (a)
With a block diagram, explain generalized measuring system with examples.
10 M
5 (b)
Define the following terms: i) Calibration ii) Sensitivity iii) Hysteresis iv) Repeatability v) Accuracy.
10 M
6 (a)
With a neat sketch, explain the working principle of a CRO.
10 M
6 (b)
With a neat sketch, explain X-Y plotter and list the advantages.
10 M
7 (a)
With a neat sketch, explain 'Hydraulic Dynomometer'.
10 M
7 (b)
With a neat sketch McLeod gauge.
10 M
8 (a)
What is a Thermocouple? State the laws of Thermocuple.
8 M
8 (b)
Sketch and explain the working principle of optical pyrometer.
12 M
More question papers from Mechanical Measurement and Metrology