STUPIDSID
Solve any one question from Q.1 & Q.2
1
A line PQ 90 mm long, is inclined to H.P and V.P at 34° and 30° respectively. Draw the projections if point P is 25 mm above H.P. and point Q is 20 mm in front of V.P. Also locate the traces.
12 M
2
A circular plate of diameter 60 mm is resting on H.P. It is then inclined to H.P. so that the point opposite to resting points is 40 mm above H.P. Draw the projections if the plan of diameter line passing through resting point makes 35° XY. Find inclinations made by the plate with reference planes..
12 M
Solve any one question from Q.3 & Q.4(a,b)
3
A cone base diameter 60 mm and axis height 80 mm is resting on H.P. on its base circumferential point. Draw the projections of its axis is inclined at an angle 35° and 30° with V.P. and H.P. respectively, with apex nearer to observer.
13 M
4(a)
Draw a helix of one revolution to a cylinder of base diameter 60 mm and axis height 120 mm.
7 M
4(b)
Draw the development of lateral surface of pentagonal prism of base side 30 mm and axis height 60 mm.
6 M
Solve any one question from Q.5(i,ii,iii,iv) & Q.6(i,ii,iii,iv)
5(i)
Figure 2 shows a pictorial view of an object. By using first angle method of projections, draw:
Front view
Front view
4 M
5(ii)
Sec. right hand side view along the line of symmetry
4 M
5(iii)
Top view
4 M
5(iv)
Dimensions.
!mage
!mage
1 M
6(i)
Figure 2 shows a pictorial view of an object. By using first angle method of projections, draw:
Sectional front view, along sectional plane
Sectional front view, along sectional plane
4 M
6(ii)
Left hand side view
4 M
6(iii)
Top view
4 M
6(iv)
Dimensions.
!mage
!mage
1 M
Solve any one question from Q.7 & Q.8
7
Figure 3 shows front view and end view of bracket. Draw isometric view and show overall dimensions.
!mage
!mage
12 M
8
Figure 4 shows front view and end view of an object. Draw isometric view and show overall dimensions.
!mage
!mage
12 M
More question papers from Engineering Graphics-1