STUPIDSID
1 (a)
Figure given below shows two views of an object. Draw the following views to full scale:-
i) Front view
ii) Left hand Side view.
Refer PDF for diagram
i) Front view
ii) Left hand Side view.
Refer PDF for diagram
9 M
1 (b)
Draw an involute of a circle of 40 mm diameter. Also draw the normal and tangent to the curve at a point 80mm from the centre of the circle.
6 M
2 (a)
The front view of a line AB 80 mm long, measures 60 mm. The end A is 15 mm infront of VP and 10 mm above HP. The end B is in third quadrant, Draw the projections of the line, if the line is inclined 30° to HP. Also find the inclination of line with VP.
7 M
2 (b)
Draw the isometric view of the following using the natural scale.
Refer PDF for diagram
Refer PDF for diagram
8 M
3
Figure shows the pictorial view of an object. Draw the following views to full scale.
i) Sectional front view along section PP.
ii) Left hand Side view
iii) Top view
Insert at least 10 major dimensions.
Refer PDF for diagram
i) Sectional front view along section PP.
ii) Left hand Side view
iii) Top view
Insert at least 10 major dimensions.
Refer PDF for diagram
15 M
4 (a)
A square prism, edge of base 35 mm and axis length 70mm, is resting on HP on one of its base edges and the axis makes an angle 40° to HP and parallel to VP. Draw its projections.
6 M
4 (b)
Draw the isometric view of the following using the natural scale.
Refer PDF for diagram
Refer PDF for diagram
9 M
5
A pentagonal pyramid has an edge of base in the H.P. and inclined at an angle 30° to the V.P. while the triangular face containing that edge makes an angle of 45° with the H.P. Draw the projections of the pyramid when the apex in nearer to the observer. The length to the side of the base of the pyramid is 35 mm and axis 70 mm.
15 M
6
A cylinder 40mm diameter and 60mm long is resting on its base on H.P. It is cut by a section plane perpendicular to VP, inclined at 45° to HP and passing through the midpoint of the axis. Draw the front view, sectional top view and true shape of the section. Also develop the lateral surface of the cut cylinder.
15 M
More question papers from Engineering Drawing