STUPIDSID
1 (a)
Explain classification of transducer.
5 M
1 (b)
What are the objective of Data Acquisition System?
5 M
1 (c)
Draw the 3 op-Amp Instrumentation Amplifier & discuss it characteristics.
5 M
1 (d)
State the Seebeck and Peltier effect in terms of thermocouple.
5 M
2 (a)
Derive an equation for dynamic response of first order instrumentation system for Ramp input. Draw the response and explain the terms measurement error and lag.
10 M
2 (b)
What is LVDT? With its characteristics explain its working. State the specifications and limitations.
10 M
3 (a)
Explain strain gauge transducer. Derive the expression of gauge factor for metal strain gauge.
10 M
3 (b)
Explain window comparator with one industrial example.
10 M
4 (a)
Derive expression for first order Low Pass filter.
10 M
4 (b)
Explain the construction and operation Electromagnetic type of flow meter.
10 M
5 (a)
Draw and explain multichannel Data Acquisition System.
10 M
5 (b)
Explain Distributed Control System (DCS) with neat diagram.
10 M
6 (a)
Explain in detail ON-OFF controller. Describe the importance of dead zone.
10 M
6 (b)
Explain in detail cascode controller with suitable example. State the advantages.
10 M
Write short notes on any three of the following:
7 (a)
Five point calibration procedure
7 M
7 (b)
Virtual Instrumentation.
7 M
7 (c)
Switch capacitor filters.
7 M
7 (d)
Logarithmic Amplifier.
7 M
More question papers from Electronics Instrumentation System