STUPIDSID
Solve All:-
1 (a)
Draw and explain the working of practical Q-meter circuit.
5 M
1 (b)
Define the following terms:
i) Accuracy
ii) Resolution
iii) Hysteresis
iv) Calibration
v) Sensitivity
i) Accuracy
ii) Resolution
iii) Hysteresis
iv) Calibration
v) Sensitivity
5 M
1 (c)
Estimate the bandwidth of CRO if a signal of 12 milisecond rise time is observed as the signal with 15 millisecond rise time.
5 M
1 (d)
Draw and explain the McLeod gauge for pressure measurement.
5 M
2 (a)
Write short note on "Programmable logic controller".
10 M
2 (b)
Draw and explain the turbine flow meter.
10 M
3 (a)
Explain the following terms related to thermocouples:
i) Law of intermediate metals.
ii) Law of intermediate temperature.
i) Law of intermediate metals.
ii) Law of intermediate temperature.
10 M
3 (b)
Draw and explain the block diagram of DSO.
10 M
4 (a)
Draw and explain the following bridges:
i) Maxwell bridge
ii) Schering bridge
i) Maxwell bridge
ii) Schering bridge
10 M
4 (b)
What are the types of errors in measurement system? Explain all in detail.
10 M
5 (a)
How the Lissajous figure are used for measurement of frequency and phase of the signal using CRO? Explain in detail.
10 M
5 (b)
Draw and explain the construction and working of electronic voltmeter using transistors.
10 M
6 (a)
Ultrasonic type level transducers.
5 M
6 (b)
Displacement measurement using potentiometers.
5 M
6 (c)
Data acquisition system.
5 M
6 (d)
Specification of CRO.
5 M
More question papers from Electronic Instruments and Measurements